Turn, Replace Bolt-On Cutting Edge MAINTENANCE It is extremely dangerous if the work equipment moves by mistake when doing this procedure. Set the work equipment in a stable condition; stop the engine; and set the safety lock for the work equipment control lever securely to the LOCK position. Remark Turn or replace the cutting edge before the wear reaches the edge of the bucket. Required Block to place under the bucket 1. Raise the bucket to an appropriate height and place a block under the bucket. 2. Set the bucket so that the bottom of the bucket is horizontal to the block and then set the center of the bucket bottom on the block. 3.
After lowering the bucket onto the block, stabilize the bucket and then stop the engine. 4. Remove bolts (1) and nuts (2) and then remove cutting edge (3). 5. Clean the mounting surface of cutting edge (3). 6. Turn cutting edge (3) and install it to the bucket. If both sides of the cutting edge are worn, replace it with a new part. If the wear extends to the mounting surface, repair the mounting surface before installing the cutting edge. 7. Tighten bolts (1) and nuts (2) uniformly so that there is no gap between the bucket and cutting edge (3). Tightening torque: . . . . . . . 883 to 1200 N•m (651.3 to 885.1 lbf ft) 8.
After operating the machine for a few hours, tighten the mounting nuts again. Lubricate Work Equipment Control Valve Linkage If the work equipment control lever is heavy or does not move smoothly, apply grease. Remark Lubricate in two places. 1. Using a grease pump, pump in grease through the grease fittings shown by arrows in the graphic. 2. After greasing, wipe off any grease that was pushed out. WA500-3LK 3-37