Komatsu — Replace Bucket Tooth with Segment Edge

MAINTENANCE Replace Bucket Tooth with Segment Edge It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable condition; stop the engine; and set the safety lock for the work equipment control lever securely to the LOCK position. Pieces may fly during the replacement operation. Always wear protective glasses, gloves, and other protective equipment. Remark Replace the bucket teeth and the segment edges before they wear down to the end face of the bucket. Required Block to place under the bucket 1. Raise the bucket to an appropriate height and place a block under the bucket. 2.

Set the bucket so that the bottom of the bucket is horizontal to the block and then set the center of the bucket bottom on the block. 3. After lowering the bucket onto the block, stabilize the bucket and then stop the engine. 4. Remove the bolt (1) and nuts (2) and then remove bucket tooth (3) and segment edge (4). 5. Clean the installation surface of bucket tooth (3) and segment edge (4). 6. Install a new tooth and segment edge to the bucket. When doing this, insert shims to remove any clearance between the tooth and top surface of the bucket. Remark The segment edge can be turned over and used again. 7.

Tighten the nut temporarily so that there is no clearance between the tooth and tip of the bucket and then hit the tip of the tooth with a hammer. Mounting bolt tightening torque Mounting bolt for bucket tooth: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 883 to 1200 N•m (651.3 to 885.1 lbf ft) Mounting bolt for segment edge: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1600 to 2160 N•m (1180.1 to 1593.1 lbf ft) 8. After operating the machine for a few hours, tighten the mounting nuts again. 3-36 WA500-3LK