Komatsu — Replace Bucket Teeth (if equipped)

Bucket with Tip Tooth MAINTENANCE It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable condition; stop the engine; and set the safety lock for the work equipment control lever securely to the LOCK position. If the pin is hit with a strong force, there is danger that the pin may fly out. Check that there is no one in the surrounding area. There is danger of pieces flying during the replacement operation. Always wear protective clothing, such as safety glasses and gloves. Remark Replace the teeth before they wear down as far as the adapters. Required Block to place under the bucket 1.

Raise the bucket to an appropriate height then put a block under the bucket. 2. Set the bucket so that the bottom of the bucket is horizontal to the block and then set the center of the bucket bottom on the block. 3. After lowering the bucket onto the block, stabilize the bucket and then stop the engine. 4. Using a rod of slightly smaller circumference than pin (1), put it in contact with the pin and then hit the rod with a hammer to remove the pin. 5. Remove tooth (2). Remark If the tooth cannot be removed by this method, for safety reasons always contact your Komatsu distributor to have the replacement carried out. 6. Clean bucket and adapter (3). 7.

Fit new tooth (2) in bucket adapter (3). 8. Insert pin (1) partially into the bucket tooth and then hit the pin with a hammer. 9. After operating the machine for a few hours, check that the pin has not come out. WA500-3LK 3-35