Komatsu — Replace Bucket Teeth (if equipped)

MAINTENANCE Replace Bucket Teeth (if equipped) It is extremely dangerous if the work equipment moves when the teeth are being replaced. Set the work equipment in a stable position; stop the engine; and set the safety lock for the work equipment control lever to the LOCK position. If the pin is hit with a strong force, there is danger that the pin may fly out. Check that there is no one in the surrounding area. There is danger of pieces flying during the replacement operation. Always wear protective clothing, such as safety glasses and gloves. One-Piece Tooth Remark Replace bucket teeth before they wear down as far as the bucket. Required Block to place under the bucket 1.

Raise the bucket to a height greater than the height of the block (A). 2. Set the bucket so that the bottom of the bucket is horizontal to the block (A) and then set the center of the bucket bottom on the block. 3. After lowering the bucket onto the block (A), stabilize the bucket and then stop the engine. 4. Remove the bolt (1) and nuts (2) and then remove bucket tooth (3). 5. Clean the installation surface of bucket tooth (3). 6. Install new teeth to the bucket. When doing this, insert shims so that there is no clearance between the teeth and the top surface of the bucket. Continue to add shims until it becomes impossible to add a 0.5 mm (0.02 in) shim. 7.

To prevent any gap from forming between the teeth and tip of the bucket, tighten bolts (1) and nuts (2) temporarily, and then hit the tip of the teeth with a hammer. Tightening torque: . . . . . . . 883 to 1200 N•m (651.3 to 885.1 lbf ft) 8. After operating the machine for a few hours, tighten the mounting nuts again. 3-34 WA500-3LK