Clean Radiator Fins and Oil Cooler Fins MAINTENANCE Never open the engine side cover when the engine is running. Stop the engine completely before starting the cleaning operation. If compressed air, pressurized water, or steam hits your body directly or causes dirt to fly, there is danger of personal injury. Always wear safety glasses, dust mask, or other protective equipment. Clean the radiator fins if any mud or dirt is stuck to the radiator or oil cooler. 1. Park the machine on a horizontal surface and turn the parking brake switch ON. 2. Stop the engine. 3. Remove four bolts (1) and remove radiator grill (2). 4.
Use the steam jet nozzle to blow out mud, dirt, or leaves clogging the radiator or cooler fins. Steam or water can be used instead of compressed air. The guideline for the spray pressure is 4 MPa (568 psi). With a nozzle (3) diameter of 2 mm (0.1 in), keep the nozzle at least 100 mm (3.9 in) away from the fins. Remark If the steam jet nozzle is brought too close to the fins, it may damage the fins. Keep the nozzle a suitable distance away from the fins when cleaning them. 5. If the mud and dirt cannot be removed by cleaning only from the radiator grill side, remove fan net (5) and clean also from radiator (4) side. 6. Check the rubber hose.
Replace it with a new one if the hose has cracks or is hardened by aging. 7. Check the hose clamps for looseness. Remark If you removed the fan net, replace it before replacing the radiator grill. 8. Replace radiator grill (2) and tighten bolts (1). Check Electrical Intake Air Heater Before the start of the cold season, ask your Komatsu distributor to check the electrical intake air heater for dirt or disconnections. WA500-3LK 3-33