MAINTENANCE Every 100 Hours Service Maintenance for every 50 hours service should be performed at the same time. Lubricate Rear Axle Pivot Pin Remark There are three lubrication points. 1. Using a grease pump, pump grease in through the grease fittings marked by the arrows. 2. After greasing, wipe off any grease that was pushed out. Clean Element in Air Conditioner Fresh Air Filter If compressed air is used, there is danger that dirt may fly and cause personal injury. Always wear safety glasses, dust mask, and other protective equipment. If the air conditioner has been used, the air filter should be cleaned. Stop the air conditioner before cleaning the element. 1. Stop the engine. 2.
Loosen bolt (1) and remove cover (2). 3. Loosen screw (3). 4. Remove element (4) and clean it. 5. Direct dry compressed air (less than 0.69 MPa (7 kg/cm 2 ) [100 psi] to the element from inside along its folds, and then direct it from outside along its folds and again from inside. 6. Install the element so that the arrow at the top of the element faces the inside of the cab. 3-44 WA500-3LK