Komatsu — Check Oil Level in Hydraulic Tank, Add Oil

Check Oil Level in Hydraulic Tank, Add Oil MAINTENANCE The parts and oil are VERY HOT immediately after stopping the engine and may cause burns. Wait for the temperature to decrease before starting the work. When removing the oil filler cap, turn it slowly to release any internal pressure and then remove it. The sight gauge is located on the outside of the hydraulic tank, on the right side of the machine. The fill port is on the right side, inside an access door at the top of the platform. 1. Lower the bucket to the ground; stop the engine; and wait for approximately five minutes. 2. Check the oil level with sight gauge (G) on the hydraulic tank.

The oil level should be between the H and L marks. Remark If the oil level is above the H level, stop the engine; wait for the hydraulic oil to cool down; then drain the excess oil from the drain plug. Using the machine with excess oil in the circuit will damage the hydraulic circuit or cause the oil to spurt out. 3. If the oil is below the L level, open the inspection cover over the step and add oil through filler (F). WA500-3LK 3-45