Komatsu — Check Battery Electrolyte Level

MAINTENANCE Every 250 Hours Service Maintenance for every 50 and 100 hours service should be performed at the same time. Check Battery Electrolyte Level Do not use the battery if the battery electrolyte level is below the LOWER LEVEL line. This situation will accelerate deterioration of the inside of the battery and reduce the service life of the battery. In addition, it may cause an explosion. The battery generates flammable gas and there is danger of explosion. Do not bring fire or sparks near the battery. Battery electrolyte is dangerous. If it gets in your eyes or on your skin, wash it off with a large amount of water and consult a doctor immediately.

When adding distilled water to the battery, do not allow the battery electrolyte to go above the UPPER LEVEL line. If the electrolyte level is too high, it may leak and cause damage to the paint surface or corrode other parts. Remark If adding distilled water in cold weather, add it before starting operations in the morning to prevent the electrolyte from freezing. Perform this check before operating the machine. See “Battery Precautions” on page 1-35. Try to check the electrolyte level on a daily basis. Be sure to check it at least once a month. Always follow the basic safety procedures.

When Checking Electrolyte Level from Side of Battery If it is possible to check the electrolyte level from the side of the battery, do this procedure. 1. Use a wet cloth to clean the area around the electrolyte level lines and check that the electrolyte level is between the UPPER LEVEL (UL) and LOWER LEVEL (LL) lines. If you wipe the battery with a dry cloth, static electricity may cause a fire or explosion. 2. If the electrolyte level is below the midway point between the UPPER LEVEL (UL) and LOWER LEVEL (LL) lines, remove cap (1) and add the distilled water up to the UL line. 3. Replace the cap (1) and tighten it securely.

Remark If distilled water is added above the bottom of the sleeve, use a syringe to lower the level to the the bottom of the sleeve. Neutralize the fluid that is removed with baking soda (sodium bicarbonate) and then flush it away with a large amount of water, or consult your Komatsu distributor or battery manufacturer. 3-46 WA500-3LK