Komatsu — Lubricating

MAINTENANCE 10. Pour in the specified amount of engine oil from oil filler (F). 11. After filling with oil, check that the oil is at the specified level. For details, see “Check Transmission Oil Level, Add Oil” on page 3- 28. 12. Check that there is no leakage of oil from the transmission case or oil filter. Clean Transmission Case Breather 1. Stop the engine and wait for the temperature of all parts to go down. 2. Remove all mud and dirt from around the breather. 3. Remove the breather and fit a cover to the breather mounting hole to prevent dirt from entering. 4. Soak the breather in cleaner fluid and wash it. 5. Install the breather. Lubricating 1.

Park the machine on a flat, level surface and lower the work equipment to the ground. 2. Shut off the engine and cycle the controls to remove any residual hydraulic pressure from the work equipment circuits. 3. Using a grease pump, pump in grease through the grease fittings marked by the arrows. 4. After greasing, wipe off any grease that was pushed out. (1) Center hinge pin (two places) (2) Drive shaft center support (one place) 3-60 WA500-3LK