Komatsu — Change Oil in Transmission Case, Clean Strainer

Every 1000 Hours Service MAINTENANCE Change Oil in Transmission Case, Clean Strainer Immediately after stopping the engine, the parts and oil are VERY HOT and may cause burns. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure and then remove the cap. Required Container to catch oil Refill capacity:. . . . . . . . . . . . . . . . . . . . . . .62 liters (16 US gallons) 1. Stop the engine and wait for the temperature of all parts to go down. 2. Set a container to catch the oil directly under drain plug (P). 3. Remove drain plug (P) and drain the oil.

To prevent the oil from spurting out, loosen drain plug (P) slowly and then gradually remove it. 4. After draining the oil, install drain plug (P). Tightening torque . . . . . . . . . . . . . . 68.6 ±9.8 N•m (50.6 ±7.2 lbf ft) 5. Set a container to catch the oil directly under the transmission filter. 6. Remove drain plug (1) of the transmission filter; drain the oil; then tighten the plug again. Tightening torque: 108 ±14.7 N•m (79.7 ±10.8 lbft) 7. Remove bolt (2); remove cover (3); and take out strainer (5), which is screwed into cover (3). 8. Remove any dirt stuck to strainer (5), then wash it in clean diesel oil or flushing oil. If strainer (5) is damaged, replace it with a new part. 9.

Install spring (4) and strainer (5) to cover (3). Replace the O-ring on the cover with a new part, then install the cover. WA500-3LK 3-59