Komatsu — Check Fan Belt for Wear

MAINTENANCE Lubricate Center Drive Shaft Spline One grease point 1. Using a grease pump, pump in grease through the grease fittings marked by the arrow. 2. After greasing, wipe off any grease that was pushed out. Check Fan Belt for Wear Check the V-belt. If any of the following conditions are present, replace or adjust the V-belt. When there is a clearance between the tension pulley lever and tip of the adjustment screw. When the V-belt makes contact with the bottom of the groove in each pulley. When the V-belt is worn and its surface is lower than the outer diameter of the pulley. When the V-belt is cracked or flaked.

A device is installed to maintain the tension constant regardless of any elongation of the V-belt. There is no need to carry out adjustment until the V-belt is replaced. When the V-belt makes an abnormal noise. 3-58 WA500-3LK