Komatsu — Replace Transmission Oil Filter Element

Replace Transmission Oil Filter Element MAINTENANCE Immediately after the engine is stopped, all parts are VERY HOT. Do not replace the filter immediately. Wait for the engine to cool down before cleaning the engine breather. High pressure is generated inside the engine fuel piping system when the engine is running. When replacing the filter, wait for at least 30 seconds after the engine stops to let the internal pressure go down before replacing the filter. When using compressed air, there is a hazard that dirt may be blown up and cause serious injury. Always use safety glasses, dust mask, or other protective equipment. Required Container to catch oil 1.

Remove cover (1) and set the container to catch the oil under the filter case. 2. Remove drain plug (2) at the bottom of the filter case; drain the oil; then tighten the plug again. 3. Loosen hexagonal portion (4) of case (3) and then remove case (3). 4. Take out the element and clean the inside of the case. 5. Replace the filter gasket and O-ring with new parts. Coat the gasket and O-ring thinly with clean engine oil before installing them. 6. Assemble the new element, then set the case in position and install it. Drain mount tightening torque: . . .49 – 58.8 N•m (36.1 – 43.4 lbf ft) Case tightening torque: . . . . . . 58.8 – 78.5 N•m (43.4 – 57.9 lbf ft) 7.

Run the engine for a short time at idling and then check that the oil is at the specified level. For details, see “Check Transmission Oil Level, Add Oil” on page 3-28. WA500-3LK 3-57