Komatsu — Replace Fuel Filter Cartridge

MAINTENANCE The cap (A) covers the large hole (C) at the top of the filter and prevents you from pouring fuel through that hole and into the clean side of the filter. The cap forces you to add the fuel through the eight holes in the dirty side of the filter. 5. Fill the filter cartridge with clean fuel through the eight small holes (B) in the new filter cartridge. 6. Coat the packing surface of the filter cartridge with oil. 7. Remove filter cartridge cap (A) and throw it away. 8. Install the filter to the filter holder. Tighten the filter cartridge until the packing surface contacts the seal surface of the filter holder, and then tighten it 3/4 of a turn.

If the filter cartridge is tightened too much, the packing will be damaged; this will result in leakage of fuel. If the filter cartridge is too loose, fuel will leak from the packing. Always tighten the filter cartridge the correct amount. 9. After replacing filter cartridge (1), loosen air bleed plug (2). 10. Loosen the knob of priming pump (3), then pump the knob and check that fuel comes out from air bleed plug (2). 11. Tighten air bleed plug (2). Tightening torque:. . . . . . . . . . . . 7.8 to 9.8 N•m (69.0 to 86.7 lbf in) 12. Loosen air bleeder (4) of the supply pump. 13.

Pump priming pump (3) (approximately 90 to 100 times) until no more bubbles come out with the fuel from air bleeder (4), then tighten air bleeder (4). Tightening torque: . . . . . . . . . . . . . 4.9 to 6.9 N•m (3.6 to 5.1 lbf in) 14. Continue pumping until priming pump (3) becomes stiff. 15. Push the knob of priming pump (3) in and tighten it. 16. After replacing the filter cartridge, start the engine and check that there is no leakage of fuel from the filter seal surface. If there is leakage of fuel, check that the filter cartridge is tightened properly. If the fuel still leaks, repeat Steps 1 and 2 to remove the filter cartridge, then check the packing surface for damage or embedded dirt.

If any problem is found, replace the cartridge with a new part, then repeat Steps 3 - 15 to install the new cartridge. 3-56 WA500-3LK