Replace Fuel Filter Cartridge MAINTENANCE Immediately after the engine is stopped, all parts are VERY HOT. Do not replace the filter immediately. Wait for the engine to cool down before starting the operation. High pressure is generated inside the engine fuel piping system when the engine is running. When replacing the filter, wait for at least 30 seconds after the engine stops to let the internal pressure go down before replacing the filter. Do not bring any fire or spark close to the machine. Be careful when opening the air bleed plug at the fuel filter head and the air bleeder of the supply pump. The system is still under pressure and fuel may spurt out.
Remark Genuine Komatsu fuel filter cartridges use a special filter that has a highly efficient filtering ability. When replacing the filter cartridge, always use a genuine Komatsu part. The common rail fuel injection system used on this machine consists of more precise parts than the conventional injection pump and nozzle. If any part other than a genuine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injection system. Never use substitute parts. When performing inspection or maintenance of the fuel system, pay more attention than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely.
Required Container to catch fuel Filter wrench 1. Set the container to catch the fuel under the filter cartridge (1). 2. Using a filter wrench, turn filter cartridge (1) counterclockwise to remove it. 3. Clean the filter holder. 4. Make sure that cap (A) is attached to the filter. Remark Cap (A) prevents the entry of dirt or dust into the filter cartridge. If fuel dust gets into the clean side of the filter, it may result in a failure of the fuel injection system. WA500-3LK 3-55