MAINTENANCE (7) Damper (one place) (8) Transmission mount trunnion (one place) (9) Fan pulley (one place) (10) Tension pulley (one place) Check Tightening Parts of Turbocharger Contact your Komatsu distributor to have the tightening portions checked. Replace Corrosion Resistor Cartridge Only when corrosion resistor is used. 1. Open the engine side cover located on the right of the engine hood. 2. Set valve (1) at the side of the corrosion resistor to the CLOSED position. 3. Using a filter wrench, turn cartridge (2) to the left to remove it. 4. Apply engine oil to the sealing surface of a new cartridge and then install it to the filter holder. 5.
When installing, bring the gasket into contact with the seal surface of the filter holder and then tighten approximately 2/3 of a turn. 6. Set valve (1) to the OPEN position. 7. After replacing the cartridge, start the engine and check that there is no leakage of water from the cartridge seal surface. 3-62 WA500-3LK