Komatsu — Change Oil in Hydraulic Tank, Replace Hydraulic Tank Filter Element

Every 2000 Hours Service MAINTENANCE Maintenance for every 50, 100, 250, 500, and 1,000 hours service should be performed at the same time. Change Oil in Hydraulic Tank, Replace Hydraulic Tank Filter Element The parts and oil are at high temperature immediately after the engine is stopped and may cause burns. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure and then remove it. Required Container to catch oil. Refill capacity:. . . . . . . . . . . . . . . . . . . .

175 liters (46.2 US gallons) Before removing the oil filter cap for filter or oil change, clean around the filter cap to avoid any dust or dirt from entering the hydraulic system. Dust or dirt can damage the system. 1. Lower the bucket horizontally to the ground and apply the parking brake. 2. Stop the engine and wait for the temperature of all parts to go down. 3. Remove the bolts and then remove the cover. 4. Remove oil filler cap (F). 5. Set a container to catch the oil under drain plug (1). 6. Remove drain plug (1). 7. Open drain valve (2) gradually and drain the oil. 8. After draining the oil, close drain valve (2) and tighten drain plug (1). WA500-3LK 3-65