Komatsu — Change Oil in Hydraulic Tank, Replace Hydraulic Tank Filter Element

MAINTENANCE 9. Remove mounting bolts (4) of filter cover (3) at one place at the top of the tank, then remove the cover. When the cover is removed, the force of spring (5) may make the cover fly off; keep the cover pushed down when removing the bolts. 10. Remove spring (5) and bypass valve (6), then remove element (7). 11. Check that there is no foreign material inside the tank, then clean it. 12. Install the new element, then set bypass valve (6), spring (5), and cover (3) to the tank. If the O-ring of the cover is damaged or deteriorated, replace it. 13. When installing the cover bolts, push down the cover and tighten the bolts evenly. 14.

Add engine oil through oil filler port (F) to the specified level, then install cap (F). 15. Check that the hydraulic oil is at the standard level. For details, see “Check Oil Level in Hydraulic Tank, Add Oil” on page 3-45. 16. Run the engine at low idling and extend and retract the steering, bucket, and lift arm cylinders four to five times. Be careful not to operate the cylinder to the end of its stroke; stop approximately 100 mm (3.9 in) before the end of the stroke. Remark If the engine is run at high speed immediately after startup or a cylinder is operated to the end of its stroke, the air taken inside the cylinder will damage the piston packing. 17.

Operate the steering, bucket, and lift arm cylinders to the end of their stroke three to four times, then stop the engine and loosen bleed plug (8) to bleed the air from the hydraulic tank. After bleeding the air, tighten plug (8) again. 18. Check that the hydraulic oil is at the standard level. For details, see “Check Oil Level in Hydraulic Tank, Add Oil” on page 3-45. 19. Increase the engine speed and repeat the procedure in Step 17 to bleed the air. Continue this operation until no more air comes out from plug (8). 20. After completing the air bleed operation, tighten plug (8). Tightening torque: . . . . . . . . . . 11.3 ±1.5 N•m (100.0 ± 13.3 lbf in) 21.

Check that the hydraulic oil is at the standard level. For details, see “Check Oil Level in Hydraulic Tank, Add Oil” on page 3-45. 22. Check that there is no leakage of oil from the filter cover mount. 3-66 WA500-3LK