Komatsu — Replace Hydraulic Tank Breather Element

Replace Hydraulic Tank Breather Element MAINTENANCE The parts and oil are VERY HOT immediately after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure and then remove it. 1. Lower the bucket horizontally to the ground and turn the parking brake switch ON. 2. Stop the engine and wait for the temperature of all parts to go down. 3. Remove the cap of oil filler (F). 4. Remove the snap ring from breather (1) and then remove the breather cap. 5. Replace the filter element with a new part. 6. Install the breather cap and snap ring. 7.

Tighten the cap of oil filler (F). Remark It is possible to replace the element with the breather installed in the tank. However, if the breather is removed, do not wrap the taper thread of the breather with seal tape when assembling again, and be careful not to tighten too much. WA500-3LK 3-67