Komatsu — BUCKET AND TIRES

OPTIONS, ATTACHMENTS BUCKET AND TIRES Select the most suitable bucket and tires for the type of work and ground conditions on the job site. Remark When installing large diameter tires you must be careful that there is sufficient clearance for the tire. Refer to “Clearance between Front Fender and Tire” on page 5-3 and “Clearance between Hydraulic Tank and Tire, between Platform and Tire” on page 5-4. BOC indicates a bolt-on cutting edge The displayed travel speed changes according to the tire size. When installing optional tires, contact your Komatsu distributor. On job sites where there are boulders or sharp rocks, install tire protectors (mesh chain).

Check the mesh chain for cuts or sagging before starting operation. Be careful not to let the tires and chain slip during operation.

5-2 WA500-3LK Type of Work Bucket Ground Conditions Tire Loading products and crushed rock Loading and carrying products Stockpile bucket (5.0 m3 (6.6 cu.yd)) (with BOC) General ground conditions 26.5-25-20PR (Rock) 29.5-25-22PR (Rock) Leveled ground Hard ground Loading products and crushed rock Excavating bucket (4.5 m3 (5.9 cu.yd)) (with teeth, segment edge) General ground conditions 26.5-25-20PR (Rock) 29.5-25-22PR (Rock) Hard ground Loading crushed rock Excavating bucket (4.5 m3 (5.9 cu.yd)) (with teeth, segment edge) General ground conditions 26.5-25-20PR (Rock, side steel breaker) 29.5-25-22PR (Rock, side steel breaker) Hard ground Spade nose rock bucket (4.3 m3 (5.6 cu.yd)) Ground with many light rocks Soft ground with many light rocks Loading and carrying crushed rock Spade nose rock bucket (4.3 m3 (5.6 cu.yd)) General ground conditions 26.5-25-20PR (Rock) 29.5-25-22PR (Rock) Hard ground Ground with many rocks and stones 26.5-25-20PR (Rock, steel breaker) 29.5-25-22PR (Rock, steel breaker) Soft ground 29.5-25-22PR (Rock)