Komatsu — Troubleshooting Auto-Greasing System

OPTIONS, ATTACHMENTS Troubleshooting Auto-Greasing System If any abnormality occurs in the greasing system, the error codes will flash alternately to display the type of abnormality. 5-14 WA500-3LK Error Code Item Cause Remedy E → a Defective pressurizing of pump • Air in main piping • Air inside pump • Grease tank is empty. • Grease leaking from main piping • Run pump as necessary and release grease from end of piping to bleed air. • Release grease from air bleed in pump to bleed air. • Add grease. • Check, tighten connections of main piping (including hoses).

E → b Abnormality in release of pressure • Abnormality in pressure- releasing structure built into pump • Abnormality in pressure- detection equipment built into pump • Disassemble pressure-releasing portion carefully, then check and clean. • Check limit switch at pressure-detection portion. E → c Abnormality in pressure detection • Abnormality in pressure- detection equipment built into pump • Abnormality in pressure- releasing structure built into pump • Check limit switch at pressure-detection portion. • Disassemble pressure-releasing portion carefully, then check and clean. E → 0 Empty tank • Greasing frequency limit has been reached. • Grease added during frequency count • Add grease.

• Reset frequency counter to zero. • Confirm that 0 flashes three times on 7-segment LED by pressing reset button on controller for more than 5 seconds.