BRAKE COOLING SYSTEM OPTIONS, ATTACHMENTS An air-cooled oil cooler may be installed to improve the cooling efficiency for the brake cooling oil (axle oil). For machines equipped with the brake cooling system, carry out the following inspection and maintenance. When Required Check Axle Oil Level, Add Oil When checking the oil, apply the parking brake and lock the front and rear frames with the safety bar. The parts and oil are at high temperature immediately after the engine is stopped and may cause burns. Wait for the temperature to go down before starting the work. When the plug is removed, oil may spurt out.
Turn the plug slowly to release the internal pressure and then remove the plug carefully. Carry out the following inspection if there are any signs of oil leakage from the axle case or brake cooling circuit. Park the machine on a horizontal surface. If the road surface is at an angle, the oil level cannot be checked correctly. Required Container to catch oil. Refill capacity:. . . . . . . . . . . . . . . . . . . . . 78 liters (20.6 US gallons) 1. Start the engine and run at low idling for at least five minutes to circulate the oil in the brake cooling circuit. 2. Stop the engine and wait for the oil temperature to go down. 3. Remove oil level plug (1). 4.
Check that the oil level is at the bottom edge of the plug hole when the engine is running at low idling. If the oil is not near the bottom of the plug hole, add axle oil through the plug hole (F). If the oil level is correct, install plug (1). Tightening torque:. . . . . . . . . . . . . 152 ±24.5 N•m (112.1 ±1.8 lb ft) WA500-3LK 5-53