OPTIONS, ATTACHMENTS Clean Axle Case Breather When checking the oil, apply the parking brake and lock the front and rear frames with the safety bar. 1. Park the machine on a horizontal surface. 2. Stop the engine. 3. Use a brush to remove all mud and dirt from around the breather. 4. Remove the breather. Remark After removing the breather, be careful to prevent dirt or dust from entering the mount. 5. Soak the breather in cleaning fluid and clean it. Clean the breather at two places (front and rear). 6. Install the breather. Clean Brake Cooling Oil Cooler Fins Never open the engine side cover when the engine is running. Stop the engine completely before starting the cleaning operation.
If compressed air, pressurized water, or steam hits your body directly or causes dirt to fly, there is danger of personal injury. Always wear safety glasses, dust mask, or other protective equipment. Clean the radiator fins if any mud or dirt is stuck to the radiator or oil cooler. Use compressed air to blow out mud, dirt, or leaves clogging the oil cooler fins. Steam or water can be used instead of compressed air. The guideline for the spray pressure is 4 MPa (568 psi). With a nozzle (3) diameter of 2 mm (0.1 in), keep the nozzle at least 100 mm (3.9 in) away from the fins. Remark If the steam jet nozzle is brought too close to the fins, it may damage the fins.
Keep the nozzle a suitable distance away from the fins when cleaning them. 5-54 WA500-3LK