Komatsu — Front Axle Oil Temperature Warning Lamp (if equipped)

OPERATION Air Cleaner Clogging Caution Pilot Lamp When the engine is running, the air cleaner clogging caution pilot lamp (8) warns the operator that the air cleaner element is clogged. Check before starting: OFF When operating: If the air cleaner becomes clogged, the caution pilot lamp and central CHECK lamp will flash. If they flash, clean or replace the element. Emergency Steering Pilot Lamp (if equipped) The emergency steering pilot lamp (9) indicates that the main pump is operating normally when the machine is traveling.

If the engine stops when the machine is traveling, or if there is any abnormality in the pump circuit, the monitor flashes (red) to indicate that the emergency steering system has been actuated. If the monitor flashes, stop the engine immediately. Front Axle Oil Temperature Warning Lamp (if equipped) The front axle oil temperature warning lamp is located below the left dash panel and acts as a warning system to inform the operator when the front axle oil temperature rises. The caution lamp turns on and the buzzer sounds continuously when the axle oil temperature reaches 102°C (216°F).

Remark When the wheel loader performs truck or hopper loading operations, it is necessary to maintain high engine RPM for optimum performance. This requires simultaneous use of the throttle and brake. This action will generate excessive heat if the T/M cutoff function is not used, thus causing the brakes to fail prematurely. If the caution lamp and buzzer turn on: Reduce travel speed as much as possible to lessen the frequency of braking application. When traveling downhill, use the engine for slowing the machine down by selecting a lower gear range. If the caution lamp does not turn off after trying these recommendations, stop the machine to allow the oils to cool down.

Restart the machine only after the overheat warnings have stopped. 2-12 WA500-3LK