Starting Switch OPERATION The starting switch (1) is used to start or stop the engine. OFF position The key can be inserted and removed at this position. When the key is turned to this position, the electric circuits are turned off and the engine stops. In addition, the parking brake is automatically applied. ON position In this position, electric current flows to the charging circuit, lamp circuit, and accessory circuit. Keep the starting switch key at the ON position while the engine is running. START position This is the engine-start position. Keep the key at this position during cranking. Immediately after starting the engine, release the key.
It will automatically return to the ON position. Transmission Cutoff Switch When moving the machine off an uphill slope, set the transmission cutoff switch to the OFF position; depress the accelerator pedal while keeping the left brake pedal depressed; then gradually release the brake pedal and allow the machine to move. This prevents the machine from traveling backwards. Press the transmission cutoff pushbutton switch (2) to turn the transmission cutoff ON and OFF. When the pilot lamp is pressed, it lights up and turns ON; if it is pressed again, the pilot lamp goes out and the transmission cutoff is turned off. Set at ON normally. OFF:
Left brake pedal acts as normal brake (like right brake pedal). ON: Left brake pedal acts as normal brake, but also switches the transmission to NEUTRAL. If the switch is turned to ON, the transmission cutoff pilot lamp will light up. Remark For general operations, using the transmission cutoff function reduces the rise in the brake oil temperature and torque converter oil temperature. WA500-3LK 2-19