Remark The length of the lever can be adjusted to three positions (A), (B), (C). To adjust the length, remove the screw at the bottom of the lever knob; slide the knob to the desired position; then tighten the screw again. (The lever is installed to position (B) when shipped from the factory.) OPERATION Gearshift Lever Stopper This stopper (3) prevents the gearshift lever from entering the 3rd or 4th position when working. Position (a): Stopper actuated. Position (b): Stopper released. Safety Lock Lever (for Work Equipment Lever) Before leaving the operator’s seat, set the safety lock lever securely to the LOCK position.
If the safety lock lever is not locked and the work equipment lever (A) is touched by mistake, this may lead to a serious accident. If the safety lock lever is not placed securely in the LOCK position, the control levers may not be properly locked. Check that the lever setting is as shown in the figure. When the safety lock lever is pulled up, do not touch the work equipment lever (A). The safety lock lever (4) is a lock device for the work equipment control lever. Push the work equipment lock lever down to lock it. WA500-3LK 2-29