Komatsu — Directional Lever

OPERATION The range of speeds during automatic gearshifting is determined by the position of the gearshift lever as shown in the chart on the right. Remark The first position for the gearshift lever fixes the transmission in 1st. There is no automatic shifting of the transmission. When shifting down from 2nd to 1st, press the kickdown switch on the lift arm control lever. If the transmission is in auto-shift and the travel speed is below 12 km/h (7.8 mph) in any speed range when traveling in either forward or reverse, the kickdown switch is actuated and makes it possible to shift down to 1st. This makes it easy to carry out load- and-carry operations.

To set the desired speed range when traveling uphill or downhill, or when carrying out grading, do as follows. When fixing the speed range: Press the HOLD switch on the lift arm control lever. The speed range is fixed at the speed range displayed on the transmission indicator on the main monitor. When shifting up or down from set speed range: Shift gear with the gearshift lever. Remark When the transmission has been shifted down from 2nd to 1st with the kickdown switch, it will shift up from 1st to 2nd when the travel speed increases. Directional Lever The directional lever (2) is used to change the direction of travel of the machine between forward and reverse.

If the directional lever is not at the N position when starting the engine, the engine does not start. Position (a): Forward Position N: Neutral Position (b): Reverse 2-28 WA500-3LK