. OPERATION DETAILED CONTROLS AND GAUGES ACCUMULATOR WARNING on the right. loosen the 3 - 74 The accumulator is ch arged with high-pressure nitrogen g as, improper operation may cause an explosion which c serious injury or dama ge. When handling the accumulator, always do as follows: Pressure in the con trol circuit cannot be completely rem oved. When removing t he hydraulic equipment, do not direction that oil sp urts out when performing the operat Loosen the bolts sl Do not disassemble Do not bring it near flame or dispose of it in f Do not make holes Do not hit it, roll it, or subject it to any impac When disposing of the accumulator, the gas mus t be rel eased.
Contact your Ko matsu distributor for proper disp This machine is equi ppedwith an accumulator i n the c ontrol circuit. The acc umulator is a device to store for the control circuit . Because an accumulato r is ins talled, the control circ uit can be actuated for a shor after the engine is s topped. As a result, if the contro l lever is moved in the LOWER direction, the work will go down under i The accumulator is installed to the position shown in Releasing Hydraulic Pressure with Accumula 1. Place the work 2. Stop the engine 3. Move lock lever strokes back an 4. Start the engine 5. Continue the op times) 6. Set lock lever to the pressure ca screws slowly, a 1.
Place the work equipment on the ground. Close the crusher attachme 2. Stop the engine 3. Move lock lever to the free position. Move t he wo rk equipment control l ever and attachment control d forth, right and left to release p ressure in the control circuit. m step 3. 4. Start the engine , then stop the engine afte r 2 - 3 seconds, then perfor 5. Continue the op eration in Step 4 until the hissing noise of pressure oil can no longer be heard. (A he hissing noise of pressure oil can no longer be heard. (A 6. Set lock lever to the LOCK position, and loc k the work equipment levers and attachment control peda nnot be completely released, so if accumulator in th oil spurts out.
e control circuit is removed, nd do not stand in the direction