Komatsu — AFTER STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS AFTER STARTING ENGINE WARNING Warming-up Operation NOTICE 3 - 99 If there has been any Emergen cy stop, abnormal actuation or trouble, turn the starting switch key If t he work equipment is operat ed without sufficiently warming the machine up, response of the wo rk equipment to movement of the control lever will be slo w, and the work equipment ma y no t respon d as the operator desi res, so always perform the warming-up operation. Particu larly in cold areas, be sure the warming-up operation is completed. When the hydraulic oil is a operations or move the le warming-up operation. This wi t a low temperature, do not perform vers suddenly.

Always perform the ll help extend the machine life. Do is Do not suddenly accelerate the completed. not run the engine at low or engine before the warming-up operation high idle continuously for more than 20 minutes. This will cause oil l piping. If it is necessary to run eaks from the turbocharger oi the engine at idle, apply a load f l supply rom time to time or run the engine at a mid-range speed. REMARK If t he hydraulic oil temperatur e is low, the hydraulic oil temperature m onitor display will be After the engine starts, do not start operating the machine i mmediately . First, carry out the following operations and checks. .

Turn fuel control dial (2) to center position (A) between the low dling (MIN) and high idling (MAX) positions and run the engine t a mid-range speed un emperature monitor gives . Set lock lever (1) slowly an d securely to the FREE position (F), hen raise the bucket from