Komatsu — AFTER COLD WEATHER SEASON

. OPERATION COLD WEATHER OPERATION AFTER DAILY WORK COMPLETION WARNING 3 - 147 Performing idle-running of the trac ks is dangerous, stay well away from the tra To prevent mud, water, or the u ndercarriage from freezing and making it impossible fo r the machine t o move o n the following morning, observe the following precautions. from the machine. In particular, remove any drops of water on the surface of the Remove any mud or water hydraulic cylinder rod.

Thes e drops of water may get inside the sea l together with mud and damage th e s Park the machine on hard, d I f this is impossible, park the The boards prevent the track s from freezing to the ground, and allow the machine t o be m oved the next morning. Open the drain valve and dr ain any water collected in the fuel syste m to prevent i t from freezing. Fill the fuel tank to capacity. This minimizes moisture condensation in the tank wh en the temperature d rop After operation in water or m ud, remove water from undercarriage a s described b elow t o extend undercarriage service life. 1. Swing 90° with engine at low idle and bring the work equipment to the side of the track. 2.

Jack up the machine until the track is raised slightly from the ground. Rotate the track under no load. Repeat this procedure on both the left and right sides. service life. 1. Swing 90° with engine at lo to the side of the track. Jack up the machine until 2. AFTER COLD WEATHER SEASON d the weather becomes warmer, do as follows. the specified fuel and oil. TS, FUEL AND COOLANT SPECIFICATIONS (PAGE 4-9)".

t antifreeze cannot be used, and an ethylene glycol base antifreeze (winter, one When the season changes an d the weather becomes warmer, do as f Replace all fuel and oil with For details, see "LUBRICAN TS, FUEL AND COOLANT SPECIFIC I f for any reason permanen t antifreeze cannot be used, and an e thylene glycol base antifreez season type) is used instea d, or if no antifreeze is used, drain the c ooling system completely . Thoroughly flush out the cooling system and fill it with fresh coolant.