Komatsu — AFTER STORAGE

. OPERATION LONG TERM STORAGE LONG TERM STORAGE BEFORE STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 148 NOTICE When storing the machine, set the machine in th shown in the diagram on the right to protect the rod . prevent rusting of the cylinder rod) (To When putting the machine in storage for a l ong time, do as follows. Clean and wash all parts, then store the machine indoors. If the machine has to be stored outdoors, sele ct level ground and cover the machine with canv as. d change the oil before storage. c cylinder piston rod with grease. he battery and cover it, or remove it from the machine and store it he lock lever and pedal lock.

Completely fill the fuel tank, lubricate an Coat the exposed portion of the hydrauli Disconnect the negative terminals of t separately. Lock each control lever and pedal with t Set the stop valve to the "lock"position o n machines ready for attachments. Install the blind p lugs to the e lbows. Set the selector valve to the "When not u se" position on machines ready for attachments. If it is necessary to perform the rust-prevention o peration while the machine is indoors, open the doors and windows to i mprove ventilation and prevent gas poisoning. During storage, operate and move the ma chine for a short distance once a month so that a ne w film of oil w ill coat moving parts.

At the same time, also ch arge the battery. For machines equipped with an air condit ioner, operate the air conditioner for three to five minutes once a month to circulate lubricant to all parts of its co mpressor. Be sure to idle the engine at low speed and operate the air frigerant twice a year. pe off all the grease from the hydraulic cylinder rods. operate conditioner. Also check the quantity of re When operating the work equipment, wi pe off all the grease from the hydraulic cylinder rods Rotate the tracks. NOTICE If the machine has been stored without carrying out the monthly rust-prevention operation, consult your Komatsu dis tributor before using it.

When using the machine after long-term st orage, do as follows before using it. ylinder rods. ts. Wipe off the grease from the hydraulic c Add oil and grease at all lubrication poin When the machine is stored for a long per iod, moisture in the air will mix with the oil. Check the oil b efore an d after starting the engine. If there is water in th e oil, change all the oil.