. MAINTENANCE MAINTENANCE PROCEDURE CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST 4 - 52 Checkin The standard deflection for th e drive belt is (A) whe n presse d with a thum b (at approx. 58.8 N {approx. 6 kg}) at a idway betwee n drive pulley (2) and (A): 10 - 15 mm (0.4 - 0.6 in) Adjustment 1. Loosen bolts and nuts (3 alternator. If nut (8) is tightened, t is loosened, the belt w 2. After adjusting the belt, reverse number order fro Check each pulley for wear of the V-belt. Ch not contact the bottom If the V-belt is elongat adjustment, or if the b When the V-belt has running for 1 hour. 1. Loosen bolts and nuts (3 ) - (7) in number order , and mo ve the alternator.
If nut (8) is tightened, t he belt tension will increase; if nut (8) loosened, the belt w ill become loose. tighten bolts and nuts (3) - (7) in 2. Afte r adjusting the belt, n reverse number order fro m (7) to (3). Finally, t ighten nu t (8) . C heck each pulley for damage, wear of the V-groov e, and ear of the V-belt. Ch eck in particular that the V-belt does of the V-groove. V-belt ot contact the bottom If the V-belt is elongat ed and there is no mor e allowan ce for djustment, or if the b elt is cracked or cut, re place th e belt. W hen the V-belt has been replaced, adjust again after again unning for 1 hour.