. MAINTENANCE MAINTENANCE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST Checking (A): 10 - 15 mm (0.4 - 0.6 in) Adjustment 3. Install cover (1). 4 - 53 1. Remove bolts (2) a nd (3), then remove c over ( 2. The standard defle ction for the drive bel t is (A) when pressed with a thumb [at a kg] at a point midway between compressor pulley 1. Loosen bolts and n uts (6) - (10) in numbe r order , and mov e the compressor. If bolt (10) is tigh the belt will become belt, tighten bolts loose. and nu er from (9) to (6). Fi ey for damage, wear nally, ti of the ghten nut V-groove, (10). and wear of the V-be not contact the b lt.
Check in particula ottom of the V-groov If the V-belt is elo ngated and there is n o mor e allowanc e for adjustment, or if the belt is cracked or cut, re place the belt. When the V-be running for 1 hou