. MAINTENANCE MAINTENANCE PROCEDURE WARNING additional fuel filter 4 - 65 REPLACE ADDITIONAL FUEL FILTER C (Machines eq uipped with additional fuel filter After the eng ine has been operated, all parts are at high temperature, so do not replace the filter imme diately. Wait for all parts to cool down before starting the operation. el piping system when the engine is running. High pressu re is generated inside the engine fu When replac ing the filter, wait for at least 30 se conds after stopping the engine to let the internal p ressure go down before replacing th e filter. any fire or flame close. hen opening the air bleed plug in the fuel filter head.
It is still under pressure, so fuel may spurt out. Do not bring Be careful w hen opening the air bleed plug in th e fuel filter head. It is still under pressure, so fuel m NOTICE Genuine Ko matsu fuel filter cartridges use a sp ecial filter that has highly efficient filtering ability. When replacing the filter cartridge, al ways use a genuine Komatsu part. The commo n rail fuel injection system used on this machine consists of more precise parts than th e conventional injection pump and n ozzle. If any part ot her than a genuine Komatsu filter c artridge is used, dust or dirt may get in and cause pro blems with the injection system. Alw ays avoid using substitute parts.
When carryi ng out inspection or maintenance o f the fuel system, pay more attention than normal to t he entry of dirt. If dirt is stuck to any part, use fuel to wash it off comple tely. Container t Prepare a f 1. Set the co cartridge. 2. Using a fil to remove 3. After remo installed t cup is use 4. Install cu cartridge. new part.) Cup tig 5. Clean the coat the p holder. NOTICE 1. Set the co ntainer to catch the fuel under th 2. Using a fil ter wrench, turn filter cartridge it. 3. After remo ving the cartridge, turn cup (2) o o the bottom of the cartridge cou d again.) p (2) to the bottom of the new 4. Install cu (When doing this, always repl htening torque: 10 Nm (1.0 kg 5.
Clean the filter holder, fill the new filter cart acking surface thinly with oil, th When addin g fuel, do not remove cap (B). Alwa small holes ( A) on the dirty side. After adding fuel, remove cap (B) and install the Always fill w ith clean fuel. Be careful not to let a the fuel. In p articular, center portion is the clean cap (B) when adding fuel. Be careful not to let dir portion on th e clean side.