Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE 4 - 66 6. When installing, tighten until the packing surface co ntacts the s eal surfac e of t he filter holder, then tighten i t 3/4 of a t urn. If the filter cartridge is t ightened too far, the packing will be da maged and this wil l lead to leakage of fuel. I f the filter c artridge is too loo se, fuel will also lea k from t he packing, so always tighten the c orrect amount When t ightening wit h a filter wrench, be extreme ly careful n ot to dent o r damage th e filter. 7. Chec k tha t the drain pl ug at the bottom of t he wate r separator cup is tightened s ecure Tightenin g torque: 0.2 to 0.45 Nm (0.02 to 0.046 k gm, 0.1 to 0 .3 lbft) 8.

When carrying out stan dard replacemen t of the fuel filter cartrid ge (every 1 000 hours), r eplace the cartridge and bleed the air. For deta ils, see "REPLACE FUEL F ILTER CAR TRIDGE ( PAGE 4-67)" 9. Start the engine, check that there i s no l eakage of f uel from th e filter seal surfac e or w ater separator mounting surface, t hen run for ap prox. 10 minutes at low idli