. MAINTENANCE MAINTENANCE PROCEDURE EVERY 1000 HOURS MAINTENANCE Maintenance for every 10, 100, 250, and 500 hours of service should be performed at the same time. REPLACE FUEL FILTER CARTRIDGE (Machines equipped with additional fuel filter cartridge) WARNING Container to catch the oil Prepare a filter wrench 1. Set the container to catch the fuel under the filter cartridge. 2. Using a filter wrench, turn filter cartridge (1) counterclockwise on remove it. 3. Clean the filter holder, coat the packing surface of the new filter cartridge thinly with oil, then install the filter cartridge to the filter holder. NOTICE Do not fill the fuel filter cartridge with fuel.
Remove cap (B) and install the fuel filter. 4 - 67 After the engine has been operated, all parts are at high temperature, so do not replace the filter immediately. Wait for all parts to cool down before starting the operation. gine is running. High pressure is generated inside the engine fuel piping system when the en When replacing the filter, wait for at least 30 seconds after stopping the eng ine to let the internal pressure go down before replacing the filter. Do not bring any fire or flame close. der pressure, so fuel may spurt out. Be careful when opening the air bleed plug in the fuel filter head.
It is still un NOTICE Genuine Komatsu fuel filter cartridges use a special filter that has highly effi cient filtering ability. When replacing the filter cartridge, always use a genuine Komatsu part. The common rail fuel injection system used on this machine consists of mor e precise parts than the conventional injection pump and nozzle. If any part other than a genuine Komatsu filter cartridge is used, dust or dirt m ay get in and cause problems with the injection system. Always avoid using substitute parts. When carrying out inspection or maintenance of the fuel system, pay more att ention than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely.