Komatsu — EVERY 1000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE 4 - 68 4. When installing , tighten until the pack ing surface contac ts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter cartr idge is tightened too f ar, the packing wil l be damaged and this will lead to leakage of fuel. If the filter cartridge i s too loose, fuel will al so leak from the p acking, so always tighten the c When tighte ning with a filter wrenc h, be extremely c areful not to dent or damage th 5. After completio n of the replacement of fuel filter cartrid Bleed the air a 6. Add fuel to the gauge). 7. After replacing filter cartridge (1), loo sen air bleed plu the filter head (2).

Loosen the kno no more bubbl b of priming pump (3), es come out of air blee then pump the kn d plug (B). Tighten air ble Tightening torq ed plug (B). ue: 4.9 to 6.9 Nm (0.5 to 0.7 kgm , 3.6 to 10. Push the knob of priming pump (3) in and tighten it. Use a genuine Komatsu part for the fuel filter cartridg replacing the fi lter cartridge, run the e ngine, and check fuel leakage fr om the filter seal surfa ce. uously for more t Do not run the starting motor contin seconds. This will put excessive load on the wiring har and starting m