. OPERATION DETAILED CONTROLS AND GAUGES 3 - 29 Starting Swi tch tch (1) is used to start or stop the engine. sition be inserted or withdrawn. Switches for the electrical ept room lamp), are all turned off and the engine is ition ent flows through the charging and lamp circuits. Keep ch key in the ON position while the engine is running. position engine-start position. Keep the key at this position ing. Immediately after starting the engine, release the utomatically return to the ON position (B). pre-heat) position Starting swi tch (1) is used to start or st (A): OFF po The key can system (exc ept room lamp), are all turned off and the engine is ition is stopped. (B):
ON pos Electric curr ent flows through the charg ing and lamp circuits. Keep starting swit ch key in the ON position while the engine is running. (C): START position engine-start position. Keep the key at this position This is the during crank ing. Immediately after star ting the engine, release the key. It will a utomatically return to the O (D): HEAT ( pre-heat) position When starti ng the engine in cold weath er, turn the key to HEAT position (D), the pre-heatin g monitor lights up. Keep the key at th is position until the monito r lamp flashes. Immediately after the pre-heating l amp flashes, release the key. The ke y automatically returns to O FF position (A).
Then , start the engine by turning t he key to START position (C). Fuel Control Dial (2) adju sts the engine speed and (a)Low idlin g (MIN): Turned fully to the (b)Full spee Cigarette Li ghter s used to light cigarettes. Lighter (3) i s used to light cigarettes. To use, pus h the lighter in. After a few seconds it will spring back. Pull out the lighter and light your cigar ette. e socket is available as a mp. By removin g the cigarette lighter, th power sourc e for the yellow flashing la Max. curren t is 85 W (24V x 3.5 A).