Operation - Section 32 1/10 OM3234 Page 32-4 Operator Cab and Controls CAB CLIMATE CONTROL Heat Control Switch Heat control switch (2, Figure 32-5) directs heated air to the cab floor for heating of the cab. The down posi- tion of the toggle switch is off. The up position of the toggle switch is on. HEATER/AIR CONDITIONER VENTS The operator has complete control of the air flow in the cab. Heater/air conditioner vents (5, Figure 32-1) are flapper-type vents. The vents may be individually opened or closed, and may be rotated 360° for opti- mum air flow.
There are four (three not shown) across the top of the panel, two in front of the operator (one each in the right and left panel modules), and four below the panel. Temperature Control Knob Temperature control knob (3, Figure 32-5) adjusts the outlet air temperature of the heater/air conditioner. HEATER/AIR CONDITIONER CONTROLS AND VENTS Rotating the knob counterclockwise (blue arrow) will select cooler temperatures. Full counterclockwise position is the coldest air setting. Heater/air conditioner unit (6, Figure 32-1) contains heater/air conditioner controls and the heater/air con- ditioner components, such as the blower motor and heater coils.
Optimum cab air climate can be selected by using the following controls in various combinations. Rotating the knob clockwise (red arrow) will select warmer temperatures. Full clockwise position is the warmest heater setting. Defroster Vent Control Switch Defroster vent control switch (1, Figure 32-5) directs heated air to the windshield for defrosting. The down posi- tion of the toggle switch is off, and the up position is on.