Komatsu — Digital Tachometer

OM3234 1/10 Operation - Section 32 Operator Cab and Controls Page 32-15 Wheel Brake Lock Switch Wheel brake lock switch (12, Figure 32- 11) must only be used when the engine is on. Use this function during dumping and loading. The brake lock switch actu- ates the hydraulic brake system, which locks the rear wheel service brakes only. When approaching the shovel or dump area, stop the truck using the service brake pedal. When the truck is completely stopped and in the loading position, apply the brake lock by pressing the rocker switch toward the ON symbol. To release, press the rocker switch toward the OFF symbol.

Parking Brake Switch Parking brake switch (13, Figure 32-11) is spring-applied and hydraulically released. It is designed to hold the truck stationary when the engine is shut off and the key switch is turned OFF. The truck must be completely stopped before applying the parking brake, or damage may occur to the parking brake. To apply the parking brake, press the rocker switch toward the ON symbol. To release the parking brake, press the rocker switch toward the OFF symbol. When the key switch is ON and the parking brake switch is applied, parking brake indicator light (A3, overhead panel) will be illuminated. NOTE: DO NOT use the parking brake at the shovel or dump.

With the key switch ON and the engine on, sudden shock caused by loading or dumping could cause the system's motion sensor to release the park brake. The wheel brake lock is used at the shovel and the dump only to hold the truck in position. DO NOT use this switch to stop the truck, unless the foot-operated treadle valve does not work. Use of this switch applies the rear service brakes with unmodulated pressure! DO NOT use the brake lock for parking because when the engine is stopped, hydraulic pressure will dissipate, allowing the brakes to release! Digital Tachometer Digital tachometer (14, Figure 32-11) displays the engine crankshaft speed in revolutions per minute (rpm). Governed rpm:

Low Idle - 750 rpm High Idle, No load - 1950 rpm maximum High Idle, Full Load - 1900 rpm