Komatsu — Engine Hourmeter

Operation - Section 32 1/10 OM3234 Page 32-16 Operator Cab and Controls Right Turn Signal Indicator Light Engine Oil Pressure Gauge Engine oil pressure gauge (20, Figure 32-11) indicates the pres- sure in the engine lubrication system in pounds per square inch (psi). Normal operating pressure after engine warm up is 138 - 250 kPa (20 to 35 psi) at idle speed. If oil pres- sure is below this range, a problem may exist. Shut the engine off and notify maintenance personnel. Right turn signal indicator light (15, Figure 32-11) illuminates to indicate the right turn signals are operating.

High Beam Headlight Indicator Light High beam headlight indicator light (16, Figure 32-11), when lit, indicates that the truck head- lights are on high beam. Engine Water Temperature Gauge Engine water temperature gauge (21, Figure 32-11) indi- cates the temperature of the coolant in the engine cooling system. The temperature range after engine warm-up in normal conditions is 74° - 91°C (165° - 195°F). Temperatures outside of this range may indicate a problem. Left Turn Signal Indicator Light Left turn signal indicator light (17, Figure 32-11) illuminates to indi- cate the left turn signals are operating.

Fuel Gauge Fuel gauge (22, Figure 32-11) indicates how much diesel fuel is in the fuel tank. Fuel tank capacity is 3217 liters (850 gallons.) Digital Speedometer/Payload Meter Display Digital speedometer / payload meter display (18, Fig- ure 32-11) indicates the truck speed in miles per hour (mph). With an optional speedometer, it may indicate the truck speed in kilometers per hour (kph). The dis- play also shows the payload meter information. For more information, see Payload Meter, Section 60. Engine Hourmeter Engine hourmeter (24, Figure 32-11) displays the total number of hours the engine has been in operation.

Voltmeter Gauge Voltmeter gauge (19, Figure 32- 11) indicates the voltage of the 24V battery system. Normal indi- cated voltage at high rpm is 27 to 28 volts with the batteries in the fully charged condition. When key switch (1) is in the RUN posi- tion and the engine is stopped, the voltmeter gauge indicates the battery charge condition.