Operation - Section 3 OM3214 Page 32-12 Operator Cab and Controls FIGURE 32-11. PANEL, GAUGES, INDICATORS, AND CONTROLS 1. Keyswitch 2. Engine Shutdown Switch with Timer Delay 3. Fog Light Switch (N./O.) ( Optional ) 4. Ladder Light Switch 5. Backup Light Switch (N./O.) 6. Panel Illumination Light(s) 7. Vent(s) - Cab Air Conditioner / Heater 8. Engine Starting Aid Switch (N./O.) ( Optional ) 9. Rotating Beacon Light Switch (N./O.) ( Optional ) 10. Heated Mirror Switch (N./O.) ( Optional ) 11. Leakage Test Switch ( Trolley Option ) 12. Wheel Brake Lock Switch (N./O.) 13. Parking Brake Switch (N./O.) 14. Digital Tachometer 15. Right Turn Signal Indicator Light 16.
High Beam Headlight Indicator Light 17. Left Turn Signal Indicator Light 18. Digital Speedometer / Payload Meter Displa 19. Voltmeter Gauge 20. Engine Oil Pressure Gauge 21. Engine Water Temperature Gauge 22. Fuel Gauge 23. Blank - Not Used In This Application 24. Engine Hourmeter 25. Blank - Not Used In This Application 26. Blank - Not Used In This Application 27. Headlights Switch (N./O.) 28. Panel Illumination Lights Dimmer Rheostat 29. Payload Meter Switch PANEL GAUGES, INDICATORS, AND CONTROLS (Figure 32-11) (1, Figure 32-11) KEY SWITCH The keyswitch is a 3-position (Off, Run, Start) switch.
When switch is rotated one position clockwise, it is in the RUN position and all electrical circuits (except START) are activated. With Selector Switch in NEU- TRAL, rotate keyswitch fully clockwise to START position and hold this position until engine starts. START position is spring loaded to return to RUN when key is released. With truck stopped, turn key- switch counterclockwise to OFF for normal engine shutdown. Use Engine Shutdown switch on center console if engine does not shutdown with keyswitch. NOTE: A ground level shutdown switch is located on lower front left side of truck.