OM3214 Operation - Section 3 Operator Cab and Controls Page 32-13 (2, Figure 32-11) ENGINE SHUTDOWN SWITCH WITH TIMER DELAY engine stops. The Ground Level Shutdown Switch will also stop the engine during this time- out. This is a 3-position rocker-type switch (Off-On- Momentary). Refer to Operating Instructions section, DELAYED ENGINE SHUTDOWN PROCEDURE, for a complete detailed operation of this switch. (3, Figure 32-11) FOG LIGHTS (OPTIONAL) 1. Press top of switch to the ON (center position), then press firmly to the “Momen- tary” (upper position) and hold this position briefly to activate the 5 Minute Idle Timer (switch is spring- loaded to return to ON posi- tion when released).
Fog Lights are optional equipment that are useful in foggy conditions and heavy rain. Pressing the top of the rocker switch turns the lights ON. Pressing the bottom of the switch turns the lights OFF. 2. When the Engine Shutdown Timer has been activated, the Timer Delay indicator light in the overhead display panel (C4, Figure 32-12) will illuminate to indicate that the shutdown timing sequence has been started. The engine will continue to run at Idle RPM for approximately 5 minutes to allow for proper engine cool-down before stopping. (4, Figure 32-11) LADDER LIGHT SWITCH The switch turns the ladder lights ON or OFF after or before using ladder.
Pressing the top of the rocker switch turns the lights ON. Pressing the bottom of the switch turns the lights OFF. Another switch is mounted at the front left of truck near the base of ladder. 3. The Engine Shutdown Timer switch DOES NOT turn off 24 VDC electric power. Turn Keyswitch counterclockwise to the OFF position to cause the engine to shutdown when timing sequence is com- plete. When the engine stops after the 5 minute idle period, the hydraulic bleeddown timer will be activated and turn off the 24 VDC electric cir- cuits controlled by the keyswitch.
(5, Figure 32-11) MANUAL BACKUP SWITCH The Manual Backup Switch allows backup lights to be turned ON providing added visi- bility and safety when the Selec- tor Switch (see OPERATOR CONTROLS) is not in REV position. When the SWITCH is pressed toward the ON position, the MANUAL BACK UP LIGHT indicator (B4, Overhead Panel) will be illuminated. Engine WILL NOT SHUT DOWN, if keyswitch is not turned to the OFF position. (6, Figure 32-11) PANEL ILLUMINATION LIGHTS NOTE: To cancel the 5 Minute Idle Timer sequence, press Timer Delay Shutdown switch to the OFF (lower) position. These lights provide illumination for the instrument panel.
Brightness is controlled by the panel light dim- mer switch (28). • If keyswitch is in OFF position, engine will stop. (7, Figure 32-11) CAB AIR CONDITIONER / HEATER VENTS • If keyswitch is in ON position, engine will continue to run. If engine does not shutdown with keyswitch, use Engine Shutdown Switch on operator cab center console, and hold this switch down until These Vents are spherically mounted and may be directed by the operator to provide the most comfort- able cabin air flow.