Operation - Section 3 OM3214 Page 32-14 Operator Cab and Controls (8, Figure 32-11) ENGINE COLD WEATHER STARTING AID (OPTIONAL) rocker switch toward the ON symbol. To release, press the rocker switch toward the OFFsymbol. Use at shovel and dump only to hold truck in position. The OPTIONAL Engine Start- ing Aid switch is spring-loaded to the OFF position. Use only when ambient temperature is below 50° F (10° C). When switch is held in the ON position, ether is injected into the engine intake man- ifold to aid engine starting in cold weather. Move the Engine Starting Aid switch to the ON position while cranking engine, for three (3) seconds maximum , and then release Engine Starting Aid.
If engine does not start, wait at least fifteen (15) seconds before repeating the procedure. Refer to Operating Instruc- tions, for more specific operating details. Do not use this switch to stop truck, unless foot- operated treadle valve is inoperative. Use of this switch applies rear service brakes at full, unmod- ulated pressure! Do not use brake lock for parking. With engine stopped, hydraulic pressure will bleed down, allowing brakes to release! (9, Figure 32-11) ROTATING BEACON LIGHT SWITCH (OPTIONAL) If truck is equipped with the OPTIONAL Rotating Beacon Light, it will be activated by this rocker-type switch when it is pressed toward the ON position.
(13, Figure 32-11) PARKING BRAKE CONTROL The Parking Brake is spring applied and hydraulically released. It is designed to hold a stationary truck when the engine is shutdown and keyswitch is turned OFF. The truck must be completely stopped before applying the parking brake, or damage may occur to parking brake.To apply the parking brake, press the rocker switch toward the ON symbol. To release the parking brake, press the rocker switch toward the OFF symbol. When the keyswitch is ON and Parking Brake switch is applied, the Parking Brake indicator light (A3, Overhead Panel) will be illuminated.
(10, Figure 32-11) HEATED MIRROR SWITCH (OPTIONAL) If truck is equipped with the OPTIONAL Heated Mirror, it will be activated by this rocker-type switch when it is pressed toward the ON position. NOTE: Do not use the parking brake at shovel or dump. With keyswitch ON and engine running, sudden shock caused by loading or dumping could cause the system's motion sensor to RELEASE the park brake. (11, Figure 32-11) LEAKAGE TEST SWITCH (Trol- ley Option Only) Refer to TROLLEY OPERATION for this switch, if truck is equipped with Trolley. (14, Figure 32-11) TACHOMETER The tachometer registers engine crankshaft speed in hundreds of revolutions per minute (RPM).
(12, Figure 32-11) WHEEL BRAKE LOCK CON- TROL The Wheel Brake Lock should be used with engine running for dumping and loading operations only. The brake lock switch actuates the hydraulic brake sys- tem which locks the rear wheel service brakes only . When pulling into shovel or dump area, stop the truck using the foot-operated service brake pedal. When truck is completely stopped and in load- ing position, apply the brake lock by pressing the Governed RPM (Komatsu Engine): Low Idle - 700 RPM High Idle, No load - 2150 RPM Maximum High Idle, Full Load - 1900 RPM