OM3214 Operation - Section 3 Operator Cab and Controls Page 32-15 (15, Figure 32-11) RIGHT TURN SIGNAL INDICATOR (20, Figure 32-11) ENGINE OIL PRESSURE GAUGE This light illuminates to indicate the right turn signals are operat- ing when the turn signal lever on the steering column is moved upward. Moving the lever to its center position will turn indicator OFF. The engine oil pressure gauge indicates pressure in the engine lubrication system in pounds per square inch (psi). Normal operat- ing pressure after engine warm up should be:
Idle - 20 to 35 psi (138 - 250 kPa) (16, Figure 32-11) HIGH BEAM INDICATOR (21, Figure 32-11) WATER TEMPERATURE GAUGE The high beam indicator when lit, indicates that the truck headlights are on HIGH beam. To switch headlights to HIGH beam, push the turn indicator lever away from steering wheel. For LOW beam, pull lever toward the steering wheel. The water temperature gauge indicates the temperature of the coolant in the engine cooling system. The temperature range after engine warm-up and truck operating under normal conditions should be:
165° - 195°F (74° - 91°C) (17, Figure 32-11) LEFT TURN SIGNAL INDICATOR (22, Figure 32-11) FUEL GAUGE This light illuminates to indicate the left turn signals are operating when the turn signal lever on the steering column is moved down- ward. Moving the lever to its cen- ter position will turn indicator OFF. The fuel gauge indicates how much diesel fuel is in the fuel tank. Fuel tank capacity is 850 gallons (3217 liters). (23, Figure 32-11) (Not Used) (18, Figure 32-11) SPEEDOME- TER / PAYLOAD METER DIS- PLAY BLANK. Not used in this truck application.
(24, Figure 32-11) HOURME- TER The speedometer indicates the truck speed in miles per hour (MPH), or with OPTIONAL speedometer, it may indicate truck speed in kilometers per hour (KPH). The display also shows Payload Meter information. For more information, see Payload Meter in Index. The hourmeter registers the total number of hours the engine has been in operation. (25, Figure 32-11) (Not Used) (19, Figure 32-11) VOLTMETER BLANK. Not used in this truck application. The voltmeter indicates the volt- age of the 24V battery system. Normal indicated voltage at high RPM is 27 to 28 volts with batter- ies in fully charged condition.
When keyswitch (10) is ON and engine is NOT running, voltmeter indicates battery charge condition. (26, Figure 32-11) (Not Used) BLANK. Not used in this truck application.