OM3214 Operation - Section 3 Operator Cab and Controls Page 32-19 The Electric System fault warn- ing light will flash on and off when a malfunction occurs in the electrical system. The warning horn will also sound intermit- tently. When light comes ON, propulsion will be dropped auto- matically. Reset by pushing override button. If fault repeats again, stop truck and report problem to maintenance personnel. D1. Electric System Fault C2. Circuit Breaker Tripped This light will illuminate if any of the circuit breakers in the relay circuit control boards are tripped. The relay circuit boards are located in the electrical control cabinet. NOTE:
Additional circuit breakers are in the operator cab behind the center console, however tripping of these circuit breakers should not activate this light. NOTE: STATEX III records the number of faults/ events. When a predetermined number of faults/ events are recorded within a given time frame, the operator will not be able to reset the fault/ event by using the override switch. If this occurs, notify maintenance personnel immediately. D2. Hydraulic Oil Filter Monitor This light indicates a restriction in the high pressure filter assembly for either the steering or hoist cir- cuit. This light will come on before filters start to bypass.
Notify maintenance personnel at earliest opportunity after light comes on. E1. Low Brake Pressure This red indicator light indicates a malfunction within the hydrau- lic brake circuit. If this light comes on and buzzer sounds, shut down truck operation and notify maintenance person- nel. NOTE: The filter monitor warning light may also illuminate after the engine is initially started if the oil is cold. If the light turns off after the oil is warmed, filter maintenance is not required. E2. Low Fuel (Optional) NOTE: Adequate hydraulic fluid is stored to allow the operator to safely stop the truck.
This amber low fuel indicator will illuminate when the usable fuel remaining in the tank is approximately 25 gallons (95 liters). A warning buzzer will also sound. A2. Low Hydraulic Tank Level (optional) This warning light indicates the oil level in the hydraulic tank is below recommended level. Dam- age to hydraulic pumps may occur if operation continues. Shut truck down and notify maintenance personnel immediately. A3. Parking Brake This amber parking brake indica- tor will illuminate when the park- ing brake is applied. Do not attempt to drive truck with park- ing brake applied. B2. Low Automatic Lubrication System Pressure B3.
Service Brake This amber light will illuminate if the Automatic Lubrication Sys- tem fails to reach 2,200 PSI (at the junction block located on the rear axle housing) within one minute after the Lube Timer indicates a cycle of grease. To turn the light off, turn key switch off, then back on again. Notify main- tenance personnel at earliest opportunity after light comes on. This amber service brake indica- tor light will illuminate when the service brake pedal is applied or when wheel brake lock or emer- gency brake is applied. Do not attempt to drive truck from stopped position with service brakes applied.