Operation - Section 3 OM3214 Page 32-22 Operator Cab and Controls E6. NOT USED Not currently used. Reserved for future use or options. TROLLEY INDICATOR LIGHTS ( Figure 32-12, Columns 7 & 8) The indicator lights shown in Figure 32-12, Columns 7 & 8, are used ONLY when the truck is equipped with the TROLLEY OPTION. If truck is equipped with Trolley, refer to TROLLEY OPERATION Section for a description of these indi- cator lights. (9) HAZARD WARNING LIGHTS The hazard warning light switch flashes all the turn sig- nal lights. Pressing the bottom side of the rocker switch (toward the triangle) activates these lights.
Pressing the top side of the rocker switch (toward the OFF symbol) turns these lights off. (10) LAMP TEST SWITCH / Centry™ Diagnostic Test Switch This switch may be used for Lamp Test, or for Centry™ diagnostic tests of a Komatsu engine equipped with Cen- try™ Fuel Control. The lamp test switch is pro- vided to allow the operator to test the indicator lamps prior to starting the engine. To test the lamps, and the warning horn, turn the key switch (1, Figure 32-11) to the RUN position and press the bottom side of the rocker switch for the “Check” position. All lamps should illuminate, except those which are for optional equipment that is not installed. The warning horn should also sound.
Any lamp bulbs which do not illu- minate should be replaced before operating the truck. Releasing the spring-loaded switch will allow the switch to return to the OFF position. For diagnostic tests of a Komatsu engine equipped with Centry™ Fuel Control, refer to Centry Diag- nostics at the end of this section.