Maintenance - Section 4 OM4042 Page 40-6 Lubrication and Service 3. 4. 5. 50 HOUR LUBRICATION AND MAINTENANCE CHECKS Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIA FAN - After the first 50 hours of operation (new truck or new fan installation), check the torque for the fan mounting capscrews -90 ft.lbs. (122 N.m). FINAL DRIVE PIVOT PIN - (If not equipped with auto- matic lube system) - Add one or two applications of grease at grease fitting. Lube Key D.
Maintenance for every 10 hours/shift checks should also be carried out at this time. 100 HOUR LUBRICATION AND MAINTENANCE CHECKS Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIA REAR HYDRAIR® SUSPENSION PIN JOINTS - (If not equipped with automatic lube system) - Add one or two applications of grease to each grease fitting for the upper and lower suspension mount pins. Use Lube Key D. BODY HINGE PINS - (If not equipped with automatic lube system) - Add one or two applications of grease to each grease fitting.
Lube Key D for the body hinge pins. HOIST CYLINDER - (If not equipped with automatic lube system) - Add one or two applications of grease to each grease fitting for bearing and pivots. Use Lube Key D. ANTI-SWAY BAR - (If not equipped with automatic lube system) - Add one or two applications of grease to each grease fitting for pin and bearings. Use Lube Key D. HYDRAULIC OIL FILTERS - Change filter elements after the initial 100 hours of operation; then at 250 hours; and then each 500 hours of operation thereaf- ter. Maintenance for every 10 & 50 hour Lubrication and Maintenance Checks should also be carried out at this time.
Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIA LS FAN - After the first 50 hours of operation (new truck or new fan installation), check the torque for the fan mounting capscrews -90 ft.lbs. (122 N.m). FINAL DRIVE PIVOT PIN - (If not equipped with auto- matic lube system) - Add one or two applications of grease at grease fitting. Lube Key D.
Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIA LS REAR HYDRAIR® SUSPENSION PIN JOINTS - (If not equipped with automatic lube system) - Add one or two applications of grease to each grease fitting for the upper and lower suspension mount pins. Use Lube Key D. BODY HINGE PINS - (If not equipped with automatic lube system) - Add one or two applications of grease to each grease fitting. Lube Key D for the body hinge pins.
HOIST CYLINDER - (If not equipped with automatic lube system) - Add one or two applications of grease to each grease fitting for bearing and pivots. Use Lube Key D. ANTI-SWAY BAR - (If not equipped with automatic lube system) - Add one or two applications of grease to each grease fitting for pin and bearings. Use Lube Key D. HYDRAULIC OIL FILTERS - Change filter elements after the initial 100 hours of operation; then at 250 hours; and then each 500 hours of operation thereaf- ter.