Komatsu — 250 HOUR LUBRICATION AND MAINTENANCE CHECKS

OM4042 Maintenance - Section 4 Lubrication and Service Page 40-7 250 HOUR LUBRICATION AND MAINTENANCE CHECKS 3. 4. 5. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS ENGINE - Refer to the engine Operation & Mainte- nance manual for complete specifications regarding engine lube oil specifications. NOTE: If engine is equipped with the CENTINEL™ ∗ oil system and/or the ELIMINATOR™ filter system, engine oil and filter change intervals are extended beyond 250 hours.

Refer to the engine Operation & Maintenance manual for specific oil & filter change intervals. a. Change engine oil. Lube Key “A”. b. Replace lube oil filters. NOTE: When installing spin-on filter elements, follow the instructions as specified by the filter manufacturer. The tightening instructions are normally printed on the outside of the filter. Do not use a wrench or strap to tighten filter elements. c. If truck is equipped with a Reserve Engine Oil Tank, change the reserve tank oil filter. d. Check the fan belt tension.Refer to the engine Operation & Maintenance manual for specific fan belt adjustment instructions.

HYDRAULIC SYSTEM FILTERS - Change filter ele- ments after the initial 250 hours; then each 500 hours of operation thereafter. FUEL FILTER AND STRAINER - Change filter and strainer element. MOTORIZED WHEEL GEAR CASE - Refer to the G.E. planned maintenance manual and specific motorized wheel service manual. STEERING LINKAGE - (If not equipped with auto- matic lube system) - Add one or two applications of grease to each grease fitting for pin and bearing. Check torque on steering pin nuts 343 ± 34 ft. lbs. (465 ± 46 N.m) torque. Use Lube Key E.

∗The Centinel™ system is a duty-cycle-dependent lubrication management system whereby oil is blended with the fuel and burned and an extension of oil change intervals can occur.