Komatsu — 250 HOUR LUBRICATION AND MAINTENANCE CHECKS

Maintenance - Section 4 OM4042 Page 40-8 Lubrication and Service 6. 7. 8. 9. 10. 11. 12. 13. 250 HOUR LUBRICATION AND MAINTENANCE CHECKS COOLING SYSTEM DCA WATER FILTER - Change spin-off filter. Check cooling system for proper coolant mixuture. Add water mixture as required. HYDRAULIC PUMP & U-JOINT - Add one or two applications of grease to each grease fitting on the cross and bearing assemblies and splines. Use Lube Key D. FRONT WHEEL BEARINGS - Check oil level. FUEL TANK - Drain H2O and sediment. . AXLE BLOWER MOTOR (If equipped with trolley sys- tem) - Add only one application of grease to each ball bearing on the blower shaft. Use lube Key D. .

GE PREFILTER BLOWER - Add one or two applica- tions of grease to the grease fitting. Use Lube Key D. . CHASSIS LUBE LEVEL - Check the level of grease in the supply canister. Add more grease to ensure the supply will not run out before the next scheduled ser- vice. Use Lube Key D. . BATTERIES (NOT SHOWN) - Check electrolyte level and add water if necessary. Maintenance for every 10 & 50 hour Lubrication and NOTE: Lube Key references are to the Lubrication Maintenance Checks should also be carried out at this Specification Chart. time. COOLING SYSTEM DCA WATER FILTER - Change spin-off filter. Check cooling system for proper coolant mixuture. Add water mixture as required.

HYDRAULIC PUMP & U-JOINT - Add one or two applications of grease to each grease fitting on the cross and bearing assemblies and splines. Use Lube Key D. FRONT WHEEL BEARINGS - Check oil level. FUEL TANK - Drain H2O and sediment. AXLE BLOWER MOTOR (If equipped with trolley sys- tem) - Add only one application of grease to each ball bearing on the blower shaft. Use lube Key D. GE PREFILTER BLOWER - Add one or two applica- tions of grease to the grease fitting. Use Lube Key D. CHASSIS LUBE LEVEL - Check the level of grease in the supply canister. Add more grease to ensure the supply will not run out before the next scheduled ser- vice. Use Lube Key D.

BATTERIES (NOT SHOWN) - Check electrolyte level and add water if necessary.