OM4042 Maintenance - Section 4 Lubrication and Service Page 40-9 500 HOUR LUBRICATION AND MAINTENANCE CHECKS 3. 4. 5. 6. Maintenance for every 10, 50, 100 & 250 hour Lubrica- tion and Maintenance Checks should also be carried out at this time. NOTE: Lube Key references are to the Lubrication Specification Chart. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS FINAL DRIVE CASE BREATHERS - Remove breather elements for motorized wheels and clean or replace elements. HYDRAULIC SYSTEM FILTERS - Replace filter ele- ments.
Check oil level. Add oil as necessary. Lube Key B. HYDRAIR® SUSPENSION - Check for proper piston extension (front and rear). THROTTLE AND BRAKE PEDAL (NOT SHOWN) - Lubricate treadle roller and hinge pins with lubricating oil. Lift boot from mounting plate and apply a few drops of oil between mounting plate and plunger. Lube Key B. HYDRAULIC TANK BREATHER - Replace breather. FRONT WHEELS - Check front wheel bearing pre- load 500 hours after truck commissioning (and at 500 hours after each rebuild) as per Section G (in the ser- vice manual for Disassembly and Assembly proce- dures) and every 5,000 hours there after.